Setup/Usage Elite Full *RUST*
Your Loader download will be included with the email you receive when purchasing your key!
SYSTEM REQUIREMENTS:
We support Windows operating system 10 version 21H1 and above
Windows version 25H2 is now supported! Anything below this build will/should work.
PROCESSOR:
Any Intel Or AMD processor is supported
The processor must have support for AVX Instructions
To check if you have AVX support, you need to download the CPUZ program from the official website. After downloading the program you need to run it, in the instruction block you should find AVX (See image below)
BIOS MODE REQUIREMENT:
We only support UEFI bios mode
To check your bios mode, search msinfo32 in the windows search box. (See image below)
In the window that opens, we look for the item "BIOS Mode" opposite it there should be an inscription UEFI. (See image below)
If there is an inscription Legacy in front of it, it's not a problem! You just need to change the BIOS mode. You will need to google how to switch from legacy mode to UEFI for your specific pc to use this product.
ADDITIONAL HELP/ERRORS:
If when attempting to launch the product it gives you an error please make a post in the "Rust Help" section on discord and we will assist you asap! Make sure to explain what error occurs. Screenshots of the error are more helpful.
LAUNCHING/USING THE PRODUCT:
Run the loader (It has admin privileges by default)
Enter your key
Wait for the product to load/check for updates (will see a percentage counter)
Once it has checked if there are any updates you can click start.
The product will now begin to load
Once it has loaded it will restart your pc.
Once your pc restarts you DO NOT need to run the loader again. Simply join rust and once on the main menu screen the loader menu usually displays on it's own. If it does not then wait a few seconds and then press the "HOME" key as this is the default menu key.
Now proceed to configure the settings to your liking
***NOTE***
You can close rust and rejoin at any time and the product will still be ready to use. No need to run the loader again unless you restart your pc OR press the "END" key which force unloads the product. Simply run rust again and it will be ready with the same settings you had configured. The product will only be unloaded when you restart your pc OR if you press the "END" key which force unloads the product and you have to start over with the loading steps again. Once your pc has been restarted you have to repeat the original process to run it again.